FS: Hard Case for Keyboard / Mixer / Other (Snowboard?)

[You Need a Thneed]

This is a heavy duty flight case that fits a mixer or a keyboard. I used it to haul around my 88 key keyboard.

Inside foam dimensions:
L - 1420mm
W - 470mm
H - 120mm






All four corners have a twisty locky thingy like in the second last pic - the lid comes completely off, there is no hinge.

$125 OBO

[Envitro]

Do you know if this will fit two turntables and a 12" mixer???

I guess I'll add up all fo the dimensions and see if it works.

[Envitro]

So, it looks like width and length would work just great, but the height is about 4-5cm too short...

[You Need a Thneed]

It certainly could fit two turntables and a mixer, the key dimension would be the width I think.

The case is actually designed for a mixer, meaning that the thin part is actually the bottom, so you could place the turntables and mixer on the bottom and just lift the big part of the case off of the top - No need to remove the bottom part of the case from underneath.

[You Need a Thneed]

Originally Posted by Envitro

So, it looks like width and length would work just great, but the height is about 4-5cm too short...

I should get a more accurate measurement for you. It would probably be possible to replace the foam in there with a little bit thinner foam, but I don't know if you'd get 4-5 cms out of doing that.

[You Need a Thneed]

Just measured it more accurately, it's at least 130mm without squishing any foam - maybe 135 or 140. If there were "feet" or something like that sticking out to 160 or 170mm, I could see it working.