My Flash Game Addiction Now

[Superflyer]

So I stumble upon this game and I am hooked.

Do you like physics?
Do you like cutting ice?
Do you like Vikings?
Well then this game is for you. You have to use your mouse to cut the ice to release the vikings and get them back into their boat.

Good luck.
http://www.xgenstudios.com/game.php?keyword=icebreaker

[Papi34]

cant get past level 19!

[Dan02]

final score 950!

[4X4]

Holy hell level 29 was hard. That took me ~20 minutes.

[photon]

Pretty cool, I stopped at 28 though..

Some good ideas in there, and the music is cool, has a monkey island kind of feel. Not very Vikingy though.

[4X4]

Dammit. I'm on 38 and I can't pass it because the G.D. screen moves with the mouse. ARGH!!

[Dan02]

Originally Posted by 4X4

Dammit. I'm on 38 and I can't pass it because the G.D. screen moves with the mouse. ARGH!!

What strategies have you tried for that one.

[4X4]

I'm trying to shave a bit of ice off each side and teeter totter it back and forth until the guys are close together, then drop them into the boat. But rushing back and forth with the mouse is making the screen move too fast.
I already tried shock and awe tactics where I cut a big chunk out of the bottom and then tried to slice and dice to get them to all fall in the boat but it's impossible to get both end guys in the boat. Driving me crazy!!

[Dan02]

Just did it a couple times again to make sure it wasn't a fluke, my solution is in white below if you wanna see it

Cut it lengthwise in half right through the dot, cut the bottem piece in half just on the left side so the 2 pieces fall into the middle of the boat to form a funnel, at this point the remaining half should be teetering to one side slightly, cut part of the lower end off just on the outside of the far viking, as it starts to swing back the other way do the same to the other side, then when it's near the middle quickly cut on both sides of the pivot point dropping everything straight down, at this point everything should be on the inside of your funnel and you just need to chop the ice up til they;re on the boat.

[4X4]

Damn. Thanks.

[4X4]

I haven't been that hooked on a game since Bloxorz. Good game. That last level is ######ed. I thought 38 was harder.

[Dan02]

Originally Posted by 4X4

Damn. Thanks.

Swarly showed me a more efficient strategy for that one too in white again

cut the bottem corner off one of the sides, wait til i drops enough that the vikings just barely start to slide and then cut right beside the pivot point on the opposite side from which you cut the corner off.

[I_am_Beast]

finished it, but it said my score was 80?

[4X4]

Originally Posted by Dan02

Swarly showed me a more efficient strategy for that one too in white again

cut the bottem corner off one of the sides, wait til i drops enough that the vikings just barely start to slide and then cut right beside the pivot point on the opposite side from which you cut the corner off.

Tried it a bunch of times and cant do it. Your technique worked better!!

[JohnnyB]

That was one of the best flash games I've played in ages. I wish it kept going past 40.

[Dan02]

These are the best scores we managed to get on each level.

1 1
2 3
3 3
4 4
5 2
6 1
7 1
8 2
9 3
10 3
11 1
12 2
13 2
14 2
15 2
16 1
17 2
18 1
19 2
20 1
21 1
22 1
23 1
24 4
25 2
26 2
27 2
28 2
29 5
30 2
31 2
32 2
33 3
34 3
35 2
36 2
37 2
38 2
39 2
40 1

[FlamesKickAss]

wow that took a while, painful on a laptop with only a touchpad

[SteveToms]

Just finished it, great game

[Barnes]

I am stuck on level 40. Any tips?

[Dan02]

Originally Posted by Barnes

I am stuck on level 40. Any tips?

2 options in white.

Firstly it is possible to fluke it out with one cut on the sprocket at the right angle, 1 success in like 40 attempts

guarenteed success way, firsly cut a small piece out of the connector that holds the wheel holding the viking so it can spin freely, after thats loose cut the top pin holding the toothed piece of ice so it falls down, then cut the rope so the other piece falls on top of it. Cut the remaining piece on the toothed piece so it starts to slide, should get the wheel spinning nice and fast, from there it is just timing, aim to cut off the wheel just below the pin when the viking is at the lowest point.