Quote:
Originally Posted by fundmark19
Do you know if it has to be Petg (I didn't watch video?) I have some black PLA + which seems to work better for me I can probably get this done for you that I was about to return.
|
Thank you for the offer! I'm not super familiar with the different materials but the Thingverse page specifies PETG. A quick search on the internet indicates that PLA might be good too? The PC case will be sitting on the 3D printed feet and the side glass panel will be sliding into the 3D printed spacer. If the material is strong enough and can handle the internal heat of a PC without deforming then I think it could be okay?
As a side note, a vendor I reached out to said it would take a couple of days and cost $98. I thought it would be a small-ish job but it might be bigger?