Quote:
Originally Posted by DoubleF
So it sounds like I'll have to spray something underneath and slowly loosen and scrape away at it? Would stuff like WD40 or Goo gone work? Or is there something else I should try?
I found a thing of Kwik seal. Does this sound like what is being used on the flange here? Is this good stuff to use to secure the new flange afterwards? or should I get something else?
Pure spit balling, Sugru might be fun to try out. 
Note: Above advice not recommended. |
This stuff? I use it, haven't had to remove it, I don't know what would loosen it up. I think you're stuck with cutting, scrapping etc. When you say flange are you talking about the bottom part of the drain assembly (under the sink)? yes you can use it on there.