Quote:
Originally Posted by Weitz
I've got a set of Calloway "warbirds" Drive - putter. Essentially a beginners club. Would hope to spend less than $800 on irons.
I shoot about 85 - 90 regularly but can't seem to improve much. The grips are starting to go so I figure I should replace everything.
|
To further the discussion on what you should do, reference this article.
http://golftips.golfweek.com/need-cu...lubs-1212.html
Getting fitted is useless if you can't hit the ball with any consistency. While a great marketing ploy, fitting is a waste of time and money unless you are a physical anomaly, being really tall, really short,having extra long arms etc. To someone with an inconsistent swing a one degree adjustment in any orientation is not going to make any difference. Same with a half inch longer club. Unless you have got your game dialed in and looking to make minuscule adjustments you're likely wasting your time and money. I equate this as to getting tailored clothes for a 10 year old. A waste of money.
Now, if you have that good swing down, and at looking to improve your game, get fittied. But make sure you do yourself the service of verifying that what you get sold is what you receive. I know of more than a few players that were told they were getting special orders but ended up with standard clubs. The only way to find out is to put them on a loft/lie machine and verify they were manufactured that way. When you do go down this road you are going to have to put your clubs on the machine and continually fine tune them back to your spec, as play will bend them out of spec and back to standard.
The bending process applies mostly to forged clubs, which are almost only blades these days. Most players are playing casted irons, which are very difficult to bent on a loft/lie machine. Casted iron is very difficult to bend as it wants to go back to the state it was originally cast to. Most club builders are not going to try and bend a casted product. A reputable club maker is not going to risk his well being and his equipment to try and bend a club that was not designed to bend. Cast irons are not designed to be bent and to do so requires more pressure than a bending machine can maintain. Something usually fails, and with a casted iron the failure is spectacular and results in shrapnel which can damage the machine and the operator. If you're thinking of bending a club make sure you're buying forged irons. Recognize that forged irons are also for advanced players and are no where near as forgiving or corrective as the casted clubs available.