Quote:
Originally Posted by FlameOn
You do not need to install all over again. I did the same switch you did in Windows 7, all you need is to boot into recovery and install the ACHI drivers.
http://solotechpros.com/2014/03/27/i...after-install/
It booted properly after that. I'm sure the process will be similar in Windows 10
|
You can also just install this:
https://support.microsoft.com/en-us/kb/922976
then reboot, set AHCI mode and be good to go. If you want, you can then install your manufacturers AHCI drivers, or they might be found automatically.