[wooohooo]

Okay so where do I begin...

I pulled a remote starter installed by some guy I bought a car off of (2006 Corolla) because I saw the connections were pretty poor so i wanted to rewire it. When I pulled the remote starter I heard a slight pop with the 12v constant ignition wire. I tried to start the car again and tried to drive it. It started fine, but the rpm gauge was at 0. I can't drive the car now either because I can't get the car out of park and the air bag light is lit. Anyone know what I can do??


Thanks for your replies. Turns out I had a burn 25A fuse under the dash. Incredibly frustrating to get at. Now that problem is fixed I have developed a new one...

The car idles and drives at low rpm causing the car to vibrate hard. The car's an automatic but when I'm putting on gas it drives fine. Normally when you turn off a car it will kind of grumble then stop. My car right now is so grumbly all the time it just turns off.... if that makes any sense.

I should also say it starts up fine and drives fine without any vibration and rpm being good then after it warms up the rpms drop and the car vibrates hard.