Just did it a couple times again to make sure it wasn't a fluke, my solution is in white below if you wanna see it
Cut it lengthwise in half right through the dot, cut the bottem piece in half just on the left side so the 2 pieces fall into the middle of the boat to form a funnel, at this point the remaining half should be teetering to one side slightly, cut part of the lower end off just on the outside of the far viking, as it starts to swing back the other way do the same to the other side, then when it's near the middle quickly cut on both sides of the pivot point dropping everything straight down, at this point everything should be on the inside of your funnel and you just need to chop the ice up til they;re on the boat.
|