Quote:
Originally Posted by guzzy
if there is already a valve on the deck it will be a 1/2" valve. Go buy some fitter's tape, 1 - 1/2"x3/8" bushing and 1 3/8" threaded pipe nipple. INstall the bushing in the valve and the nipple in the bushing. Your BBQ will have a quick connect installed. The threaded end connects to the nipple. Then re-connect the quick connect and turn on the gas. put a bit of water/dishwashing soap mix on the joints. If it bubbles you have a leak.
Go to home depot they will give you everything you need. YOu only need two wrenches to install. Just remember that you need tape on every threaded joint. It is very simple.
|
I think he said there was no lever which I would assume means there is just a capped line, in which case he would have to shut the gas off at the meter before installing the quick connect.